Chamfer and trimming cutter
Inclined cutters for engraving and chamfering shank with cylindrical shank

The inclined cutters are produced to a sharp and double-edged, with or without a guide bearing for all the work you want to do.
We also produce cutters bearing plans to join in Korian ®.
Type 3
Type 3
Type 3 Dovetail cutter Dovetail cutter The dovetail joint allows for sturdy and resistant assembling. Suggested for wood, which has not a strong tightness to nails and screws, such as beechwood.
Type 3
Type 3
Type 3 Dovetail cutter with bearing guide Dovetail cutter Suitable for the router table and jig CDR 200 (simple execution).
Type 4
Type 4
Type 4 Chamfer cutter Chamfer cutter The chamfer cutters can be used for inclined rebatings or for moulds. This joint will also enable you to build frames for dividing panels with climbing plants.
Type 4S
Type 4S
Type 4S Chamfering pivot cutter Chamfering pivot cutter This cutter will enable you to produce bevel edges even in narrow corners, because the pivot replaces the guide of the machine. Practical advice: rub some paraffin on the pivot and the wood-piece, in this way you will avoid overheating of the wood.
Type NC1
Type NC1
Type NC1 Cylindrical/bevel trimming cutter Cylindrical/bevel trimming cutter
Type 5
Type 5
Type 5 V-Grooving cutter V-Grooving cutter It can be used for writing, engraving of geometrical patterns or free-hand drawings. The 45° model is also used for making grooves in plasterboards.
Type CS
Type CS
Type CS Cylindrical and bevel trimming cutter Cylindrical and bevel trimming cutter This tool doubles in the hands of an expert carpenter, because it can trim straightforward and slantwise. Practical advice: by adjusting the height, this tool can be used to remove the sharp edge left over after working on a rolled plastic section.
Type C2S
Type C2S
Type C2S Bevel trimming cutter Bevel trimming cutter
Type C2S k corian ®
Type C2S k corian ®
Type C2S k Chamfer cutter for corian ® Chamfer cutter for corian ® With this cutter you can round off a corner and join up two inclined surfaces. Thanks to its special angled ball bearing, which is coated with plastics, the cutter leaves no traces on the workpiece.
Chamfer and trimming cutter